 |  | 
New Page 1
FSP600-80GLC (ATX / EPS 12V)
EPS 12V
600W ATX12V | EPS12V PC and
Server Workstation, energy saving ultra-high efficiency, 80PLUS Certified,
Active PFC, 80mm ball-bearing fan, noise-killer, full-range input, on/off
switch, main connector 20 + 4-pin, EPS 8-pin, (2) Serial-ATA , (9) molex 4-pin,
(1) FDD 4-pin, environmental friendly with strictly qualified RoHS, Green
Product status.
Watt: 600
Dimension:
140 x 150 x 86mm
Features:
Full-Range Input | 600W
Ultra-high efficiency | Energy Saving
Active Power Factor Correction (PFC)
Low Ripple & Noise
Over voltage protection on all outputs
Short circuit protection on all outputs
Resetable power shut down
Internal 80mm ball-bearing fan
Low Noise Design at full load
100% burn-in under high ambient temperature(50°C)
Vacuum-impregnated transformer
MTBF:100K hours at 25°C
100% Hi-pot tested
Line input fuse protection
Complies with EN61000-3-2
Input Characteristics:
Input voltage: 90 to 264 VAC
Input frequency: 47 to 63 Hz
Input current: 7.5A/115Vac, 3.5A/230Vac
|
Specifications:
Over voltage protection: +3.3V: 3.76V - 4.8V
+5V: 5.6V - 7.0V
12Vdc: 13.5V - 15.6V
Over current protection: The power supply is prevented from output over
current.
Short circuit protection: The short circuit on any DC output shall not cause
any damage to the power supply, including the primary fuse.
GENERAL SPECIFICATIONS
Hold-up time: 17ms at 115Vac/60Hz, 17ms at 230Vac/50Hz.
Efficiency: 80%+ /115V; 83%/ 230V (Typical load)
MTBF: 100,000 hours at full load at 25℃
ENVIRONMENTAL SPECIFICATIONS
Operating temperature: 0 to +50 degree C
Storage temperature: -20 to +80 degree C
Relative humidity: 5% to 95% RH; non-condensing
***80
Plus Certified power supply |
Output Characteristics
|
Output
Voltage |
Minimum Load |
Normal Load |
Maximum Load |
Load
Reg. |
Line
Reg. |
Ripple |
Ripple & Noise
|
|
+3.3V |
0.8A |
18A |
36A |
± 5% |
± 1% |
50mV P-P |
100mV P-P |
|
+5V |
0.5A |
15A |
30A |
± 5% |
± 1% |
50mV P-P |
100mV P-P |
|
+12V1DC |
0A |
7.5A |
15A |
± 5% |
± 1% |
120mV P-P |
200mV P-P |
|
+12V2DC |
0A |
7.5A |
15A |
± 5% |
± 1% |
120mV P-P |
200mV P-P |
|
+12V3DC |
0.9A |
7.5A |
15A |
± 5% |
± 1% |
120mV P-P |
200mV P-P |
|
+12V4DC |
0.1A |
7.5A |
15A |
± 5% |
± 1% |
120mV P-P |
200mV P-P |
|
-12V |
0.0A |
0.25 A |
0.8 A |
± 10% |
± 1% |
120mV P-P |
200mV P-P |
|
+5Vsb |
0.0A |
1.0 A |
2.0 A |
± 5% |
± 1% |
50mV P-P |
100mV P-P |
*+3.3V
and +5V total output not exceed 155W
*Total output for this
subject power supply is 600W
|
| | |