Shop By Manufacturer
200W Flex ATX Power Supply Model # FSP200-50PLA
Model # FSP200-50PLA
Features
- Flex ATX and ATX12V standard
- Active PFC
- Internal DC fan
- Low noise and ripple
- 100% hi-pot, ATE and burn-in tested
- Output over voltage, short circuit, and over current protection
- Re-settable power shut down
- Remote on/off function
Specifications
Output Wattage |
200 Watts |
Input Voltage |
90-264VAC Full Range |
Frequency |
47~63 Hz |
Input Current |
4A (RMS) @115V AC 2A (RMS) @230VAC |
Inrush Current |
50A Max for 115V AC, 80A Max for 230V AC Cold start |
Temperature |
0±C ~ +25±C operating; -20±C ~ +80±C storage |
Humidity |
95% operating; 95% storage |
Dielectric Withstand |
Input to frame ground 1800V AC for 1 second |
Efficiency |
68% at minimum measured at nominal AC main voltage and frequency with maximum load on all output |
Hold-up Time |
17ms minimum at full load & nominal input voltage |
Power Good Signal |
Power on delay time 100 ms to 500 ms, off delay 1ms minimum (TTL and CMOS compatible) |
Leakage Current |
Not exceed 0.75mA at 240V AC, 50Hz |
MTBF |
100,000 hours on maximum load at +25±C degree |
Length |
6 in. (150 mm) |
Width |
3.2 in. (81.5 mm) |
Height |
1.6 in. (40.5 mm) |
Certifications |
Safety:UL 1950, CSA C22.2 Level 3, TUV EN60950,
NEMKO (CB Report) Complies with FCC part 15 subpart J Class B and CISPR 22 Class B Meets with EN61000-3-2 (Active PFC ) |
Output Characteristics |
||||||
| Output Voltage | Output Current |
Regulation |
Output Ripple & Noise Max [P - P] |
|||
Min [A] |
Max [A] |
Peak |
Load |
Line |
||
+3.3V |
0.3 |
16 |
-- |
±% |
±% |
50mV |
+5V |
0.3 |
12 |
-- |
±% |
±% |
50mV |
+12V |
1.5 |
12 |
-- |
±% |
±% |
120mV |
-12V |
0 |
0.8 |
-- |
±0% |
±% |
120mV |
+5Vsb |
0 |
2.0 |
-- |
±% |
±% |
120mV |
+5V and +3.3V total output not exceed 61W
+3.3V, +5V, and +12V total output cannot exceed 180W
Frequently Bought Together With
Special Offers *
Customer Account
Customer Service
Signup Newsletter
© 2001-2015 Mypccase.com All rights reserved.