Home | Power Supplies| 1U Single| Sparkle Power 1U 250W ATX12V 80Plus Switching Power Supply, Model # SPI2501UH

Sparkle Power 1U 250W ATX12V 80Plus Switching Power Supply, Model # SPI2501UH

My Pc Case
Sparkle Power 1U 250W ATX12V 80Plus Switching Power Supply, Model # SPI2501UH
My Pc Case

Item#:

SPI2501UH

Price:

$75.00

Sale Price:

$54.99
(You Save $20.01 )
Quantity:
My Pc Case
Bookmark and Share
My Pc Case
My Pc Case

Features
• Complied with ATX 12V standard
• Active Power Factor Correction (PFC) meet EN61000-3-2
• High efficiency and reliability
• Compatible with European Union Directive 2002/95/EC (Restriction on Hazardous Substances).
• Remote ON/OFF function
• Internal 12V DC fan included
• Noise Killer (thermal fan speed control function)
• Low noise and ripple
• Output over voltage, short circuit, and over current protection
• 100% Hi-pot, ATE, and burn-in tested
• Re-settable power shut down
• Complies with FCC part 15 subpart J class B 115Vac operation, and CISPR 22 class B at 230Vac operation Approved by UL,CSA22.2 NO or CUL 609 EMC,FCC ,CE, CB report.

Input Characteristics
Input Range: 90 ~ 264Vac, Full Range Input
Frequency: 47 ~ 63Hz
Input Current: Max 5A @ 115Vac, 3A@ 230Vac
Inrush Current: No damage.

Iutput Characteristics Specification
• Temperature Range:Operating: 0˚C ~ +50˚C on full load; storage & shipping: -20˚C ~ +80˚C
• Humidity: 5-90% on operating, 5-95% on storage
• Dielectric Withstand:Primary frame ground 1800V AC for1 second
• Efficiency: typical up to 84%
• Rise time: Less than 20ms
• Hold-up Time: 17ms minimum at nominal input voltage
• Power Good Signal:Power on delay time 100 ~ 500ms, off delay 1ms minimum (TTL and CMOS compatible)
• Leakage Current: Less than 3.5mA at 264Vac, 50Hz
• MTBF: 100,000 hours on maximum load at +25˚C
• Dimensions (LxWxH): 190x100x40.5mm /7.5x3.9x1.6inch

Output Voltage Minimum Load Normal Load Maximum Load Load Reg. Ripple & Noise
+3.3V 0.5A 8A 16A + - 5% 50mV P-P
+5V 0.5A 9A 18A + -5% 50mV P-P
+12V1 1.0A 8A 16A + - 5% 120mV P-P
+12V2 1.0A 8A 16A + - 5% 120mV P-P
-12V 0.0A 0.4A 0.8A + -10% 120mV P-P
-5V 0.0A 0.15A 0.3A + -10% 100mV P-P
+5Vsb 0.0A 1.25A 2.5A + - 5% 50mV P-P

+3.3V and +5V total output not exceed 120W
Total output for this subject power supply is 250W

My Pc Case